SID and STAR How to Read?
Interactive SID Chart
Two RNAV departures from runway 27 at LTXX: KAVUN 1A to the north, ELMAS 1A to the south. Tap the numbered areas or start the tour. Fictional chart; not for actual flight use.
On a phone, you can zoom in on the chart with the "Zoom" button and pan across it. All values are fictional.
Procedure Name: KAVUN 1A
A SID name has three parts: the exit point (KAVUN), the validity number (1) and the route letter (A). The number increases when the procedure changes: KAVUN 2A. SIDs from different runways to the same point get different letters.
Constraint Reading Test
The lower line is the "floor" (do not descend below it), the upper line is the "ceiling" (do not climb above it). What does the incoming restriction mean? How far can you extend the series?
Climb Gradient Calculator
SID gradient is given as a percentage or ft/NM; in the cockpit you see ft/min on the VSI. Enter your groundspeed and aircraft's climb rate to see whether you can meet the SID.
Gradient → Climb Rate
Mental Calculation
- ft/NM ≈ percent × 60 (5% → 300 ft/NM; exact value 304).
- ft/min = ft/NM × groundspeed ÷ 60. If groundspeed is 120 kt, then ft/NM × 2.
- Standard gradient 3.3% (≈ 200 ft/NM): obstacle surface 2.5% + 0.8% obstacle clearance.
- A tailwind increases groundspeed, so the same gradient requires a higher ft/min. Performance decreases at hot and high aerodromes.
Interactive STAR Chart
Two RNAV arrivals to LTXX: ARMUT 1T from the northwest, TOKAL 1T from the southwest. Both end at the IAFs for ILS RWY 27 (ALPHA, CHARLIE), so you can brief the arrival and approach together.
STAR Name: ARMUT 1T
The STAR name is read the same way: starting point (ARMUT), validity number (1) and route letter (T). A STAR is the arrival route from the airway to the initial approach fix (IAF) where the approach begins.
Parts of a SID and STAR
SID
- Procedure Name: KAVUN 1AA SID name has three parts: the exit point (KAVUN), the validity number (1) and the route letter (A). The number increases when the procedure changes: KAVUN 2A. SIDs from different runways to the same point get different letters.
- Departure Frequency and Transition AltitudeAfter takeoff, the tower hands you over to Departure (124.100). Transition altitude 10000 ft: when climbing, set the altimeter to 1013 at this altitude.
- First Climb: Climb Via SID"Climb via SID to 6000 ft" clearance: climb to 6000 ft following all altitude and speed restrictions on the SID. 6000 ft is the "stop altitude"; you stay there until ATC gives a higher level.
- Climb GradientStandard gradient 3.3% (≈ 200 ft/NM). If there is an obstacle the chart requires more: here 5.0% up to 3000 ft (304 ft/NM). The table on the right converts this gradient to ft/min by ground speed: 760 ft/min at 150 kt.
- Speed Restriction"MAX 210 KT": speed does not exceed 210 kt up to the stated point. The turn radius grows with speed; the restriction keeps the turn within the protected area.
- Runway and DERThe departure procedure begins at the departure end of runway (DER). According to ICAO, no turn is made before reaching 394 ft (120 m) above the DER.
- Fly-over WaypointA star inside a circle is a fly-over point: the aircraft passes directly over the point and only then begins the turn. The turn begins after LX501.
- Fly-by WaypointA star without a circle is a fly-by waypoint: the aircraft starts turning before reaching the point and joins the next leg smoothly. It is the most common waypoint type in RNAV SIDs and STARs.
- At or AboveAn underlined altitude means "at or above": cross LX502 at 4000 ft or higher. FL80 at KAVUN is the same: FL80 or above.
- At or Below (At or Below)A struck-through altitude means "at or below": cross LX503 at 5000 ft or lower. It is usually for separation from other traffic, such as arrivals.
- Exact Altitude (At)Both an upper and a lower altitude are mandatory: cross ELMAS at exactly 6000 ft. If there are two values with one between them (upper bar on top, lower bar below), it means "between two values".
- Exit Point and Route NameKAVUN is the point where the SID ends and connects to the airway network. The "KAVUN 1A" in the box shows which line is which SID.
- ObstacleThe 1450 ft obstacle (antenna) is the reason for the 5.0% gradient requirement. The obstacle symbol is an inverted V; the number beside it is its height above mean sea level.
- Minimum Sector AltitudeA safe altitude giving 1000 ft obstacle clearance within 25 NM of the aerodrome. Used in an emergency on departure or when position is lost.
- Route DescriptionThe text under the chart describes the route with waypoints and constraints: + "at or above", − "at or below", K210− "at or below 210 kt". You compare the route loaded into the FMS against this text.
STAR
- STAR Name: ARMUT 1TThe STAR name is read the same way: starting point (ARMUT), validity number (1) and route letter (T). A STAR is the arrival route from the airway to the initial approach fix (IAF) where the approach begins.
- Descend Via STARWith a "Descend via STAR" clearance, you plan your own descent while complying with all restrictions. Notes also indicate the expected approach: ILS RWY 27 (chart 11-1).
- Speed LimitMaximum 250 kt below FL100. The "MAX 250 KT" on LX601 is the same limit. When descending, plan your slowdown early to meet both the altitude and speed restrictions.
- Starting PointARMUT is the point where the STAR is entered from the airway. It must be the same as the last airway waypoint in the flight plan.
- Between Two ValuesStruck-through FL100 above, underlined FL80 below: cross LX601 between FL80 and FL100.
- At or AboveCross LX602 at 6000 ft or above. In descent, the "at or above" constraint prevents descending early and approaching obstacles or other traffic.
- IAF and HoldingThe STAR ends at exactly 4000 ft at ALPHA, the initial approach fix (IAF) for ILS RWY 27. There is a holding pattern at ALPHA: if delayed, you hold here.
- Connection to ApproachFrom ALPHA and CHARLIE, descend to BRAVO (IF) and enter ILS RWY 27. Dashed lines continue on the approach chart.
- At or Below (At or Below)Cross LX603 at or below FL90 at TOKAL 1T. Overlined altitude: do not climb above it.
Frequently Asked Questions
What Is a SID?
A SID (Standard Instrument Departure) is the standard departure route flown from the runway to the airway network in instrument departures. It is an obstacle-protected route containing altitude and speed restrictions and the required climb gradient. It shortens radio communication and organises traffic.
What Is a STAR?
A STAR (Standard Terminal Arrival Route) is the standard arrival route flown from the airway to the initial approach fix (IAF) where the approach begins. It includes altitude and speed constraints for descent. At busy aerodromes, ATC often gives radar vectors instead of a STAR.
How Is the Climb Gradient Calculated?
Gradient (ft/NM) = percentage × 60.76. Required climb rate (ft/min) = groundspeed (kt) × gradient (ft/NM) ÷ 60. Example: 5% = 304 ft/NM; at 150 kt groundspeed, 304 × 150 ÷ 60 = 760 ft/min.
What Does Climb Via SID Mean?
The pilot follows all altitude and speed restrictions on the SID, climbing to the altitude given in the clearance (stop altitude). No separate ATC permission is needed between restrictions.
What Is the Difference Between Fly-by and Fly-over?
At a fly-by waypoint the aircraft starts the turn before reaching the point and joins the next leg smoothly. At a fly-over waypoint the aircraft passes directly over the point and only then starts the turn. On the chart, a fly-over waypoint is shown inside a circle.
What Do Upper and Lower Bars Mean?
An underlined altitude means "at or above", an overlined altitude means "at or below", and an altitude both underlined and overlined means "at" (exact altitude). If two altitudes are written one above the other, it means "between".
Next Steps
The charts on this page are fictional training examples; for actual flight, only the currently valid official publications (AIP) are used.