Stability

Turkish: Dengelilik

PPLATPL Flight Principles
IN SHORT

Stability is the tendency of an aircraft to return by itself to its original state after being disturbed; longitudinal stability depends largely on the position of the centre of gravity.

What is Stability?

Static stability describes the initial response (the tendency to return), while dynamic stability describes the motion over time (the damping of oscillations). Stability is examined about three axes: longitudinal (pitch; horizontal stabiliser and CG position), lateral (roll; wing dihedral, high wing) and directional (yaw; vertical stabiliser).

The further forward the centre of gravity, the more longitudinally stable the aircraft, but the control force becomes heavier and the stall speed rises slightly. As the CG moves aft, stability decreases and control becomes more sensitive; beyond the aft limit the aircraft may become unstable and difficult to recover from a stall or spin.

TEST YOURSELF

What happens if the centre of gravity is aft of the aft limit?

How it is asked in the ATPL exam: 3 questions

Think about your answer, then reveal it.

1. Which characteristics must a hydraulic fluid have? Select the combination that lists only the correct properties:
1. thermal stability
2. low emulsifying characteristics
3. corrosion resistance
4. good resistance to combustion
5. high compressibility
6. high volatility
7. high viscosity

  1. 1, 3, 4, 6
  2. 2, 3, 4, 5
  3. 1, 2, 3, 4
  4. 1, 2, 5, 7
Show answer

Correct answer: 1, 2, 3, 4

Hydraulic fluids must be thermally stable, resist emulsification and corrosion, and resist combustion. High compressibility, high volatility, and high viscosity are undesirable properties that reduce system efficiency and safety.

2. An aircraft has a manoeuvre stability value of 150 N/g. What stick force is needed to pull up from level flight to a load factor of 2.5 g?

  1. 150 N.
  2. 450 N.
  3. 375 N.
  4. 225 N.
Show answer

Correct answer: 225 N.

Manoeuvre stability (stick force per g) multiplied by the change in load factor gives total stick force: 150 N/g × (2.5 − 1.0) g = 225 N.

3. What happens to static longitudinal stability when the centre of gravity moves aft?

  1. increases static longitudinal stability.
  2. decreases longitudinal manoeuvrability.
  3. decreases static longitudinal stability.
  4. has no influence on longitudinal manoeuvrability.
Show answer

Correct answer: decreases static longitudinal stability.

An aft CG shift reduces the distance between the centre of gravity and the neutral point, decreasing the restoring moment and thus static longitudinal stability.

Solve 10 free questions from this subject →

Frequently asked questions about Stability

What is the difference between static and dynamic stability?

Static stability describes the initial response, i.e. the tendency to return. Dynamic stability describes how the motion, i.e. the oscillations, is damped over time.

About which axes is stability examined?

Stability is examined about three axes: longitudinal (pitch), lateral (roll) and directional (yaw). Longitudinal stability depends largely on the position of the centre of gravity.

Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 18 Nov 2026 · Report an error: [email protected]