Управление смесью

Турецкий: Karışım (Mixture)

PPL Общие знания о воздушном судне
IN SHORT

The mixture control sets the fuel-air ratio delivered to the cylinders. As air thins with altitude, the mixture is leaned to restore the correct ratio.

Что такое управление смесью?

At high altitude the same volume of air contains less oxygen, but the carburettor continues to deliver the same amount of fuel. The mixture becomes too rich: power falls, the engine runs roughly, spark plugs foul with carbon deposits and fuel is wasted. Pulling the mixture control back leans the mixture by reducing fuel flow.

An excessively lean mixture, however, raises cylinder head temperature (CHT) and can lead to detonation. For take-off and climb, full rich is generally used (near sea-level aerodromes); at high-elevation aerodromes, leaning before take-off may be carried out in accordance with the aircraft flight manual. To shut the engine down, the mixture is moved to idle cut-off (fully lean).

TEST YOURSELF

Что происходит, если не корректировать смесь во время набора высоты?

Как формулируется вопрос на экзамене PPL: вопросы 2

Подумайте над ответом, затем откройте его.

Экзамены по теоретическим знаниям EASA проводятся на английском языке, поэтому вопросы и варианты ответов показаны на английском. При необходимости откройте перевод под каждым вопросом; объяснения даны на вашем языке.

1. In a piston engine, why is an altitude mixture control needed?

  1. Weaken the mixture strength because of reduced exhaust back pressure at altitude.
  2. Prevent a weak cut when the throttle is opened rapidly at altitude.
  3. Correct for variations in the fuel/air ratio due to decreased air density at altitude.
  4. Enrich the mixture strength due to decreased air density at altitude.
🌐 Русский · Показать перевод

Зачем в поршневом двигателе нужен высотный регулятор смеси?

  • A) Обеднить смесь из-за снижения противодавления выхлопных газов на высоте.
  • B) Предотвратить обеднение при резком открытии дросселя на высоте.
  • C) Компенсировать изменения соотношения топлива и воздуха из-за уменьшения плотности воздуха на высоте.
  • D) Обогатить смесь из-за уменьшения плотности воздуха на высоте.
Показать ответ

Правильный ответ: Correct for variations in the fuel/air ratio due to decreased air density at altitude.

С увеличением высоты плотность воздуха уменьшается, и смесь становится относительно слишком богатой. Регулятор смеси позволяет пилоту уменьшить подачу топлива для поддержания правильного соотношения топлива и воздуха.

2. During flight, to set the correct fuel/air mixture, you move the mixture control towards LEAN until engine RPM drops. What do you do next?

  1. Rises and then the mixture control is left in that position
  2. Drops and then mixture control is then moved slightly to the RICH side of peak RPM
  3. Decreases by approximately 150 RPM. The mixture control is then moved slightly more towards the lean position
  4. Decreases. The mixture control is then left in that position
🌐 Русский · Показать перевод

В полёте, чтобы установить правильную топливовоздушную смесь, перемещайте рычаг смеси к LEAN до падения оборотов двигателя. Что вы делаете дальше?

  • A) Поднимаются, затем рычаг смеси оставляют в этом положении
  • B) Сначала обороты падают, затем смесь немного переводится в положение RICH относительно пика оборотов
  • C) Уменьшаются примерно на 150 об/мин. Затем рычаг смеси немного сдвигают дальше в сторону обеднения
  • D) Уменьшаются. Рычаг смеси затем оставляют в этом положении
Показать ответ

Правильный ответ: Drops and then mixture control is then moved slightly to the RICH side of peak RPM

Затем слегка переместите рычаг обратно к положению RICH, чтобы найти точку пикового оборота, которая указывает на наиболее эффективное состав смеси.

Решить 10 бесплатных вопросов по этой теме →

Frequently asked questions about Mixture Control

Why is the mixture adjusted at high altitude?

Mixture control is adjusted at high altitude because the air thins, so the carburettor produces a mixture that is too rich. Pulling the mixture control back reduces fuel flow; otherwise power falls and the engine runs roughly.

What happens if the mixture is too lean?

An excessively lean mixture raises cylinder head temperature (CHT) and can lead to detonation. To shut the engine down, the mixture is moved to idle cut-off (fully lean).

Машинный перевод (ИИ) с нашего Turkish glossary entry по терминологии ICAO/EASA. Обновлено 16 2026 · Сообщить об ошибке: [email protected]