VR
VR is the speed at which the pilot begins to rotate the aircraft, raising the nose, during the take-off run.
What is VR?
On large aeroplanes, VR is derived from the performance calculation and cannot be lower than V1. Rotation is made so that V2 (the take-off safety speed) is reached at a height of 35 ft. On light aeroplanes, the POH gives VR (or "liftoff speed") for a specific flap setting and weight.
Rotating too early may cause the aeroplane to drag its tail and strike the tail on the ground, due to excessive angle of attack; rotating too late results in a longer take-off distance.
What is the relationship between V1 and VR on jet aeroplanes?
VR cannot be lower than V1.
How it is asked in the PPL exam: 3 questions
Think about your answer, then reveal it.
1. During take-off, your aircraft reaches the rotation speed VR. Which statement correctly describes what VR is?
- VR is the speed at which rotation should be initiated.
- VR is the lowest speed for directional control in case of engine failure.
- In case of engine failure below VR the take-off should be aborted.
- VR is the lowest climb speed after engine failure.
Show answer
Correct answer: VR is the speed at which rotation should be initiated.
VR (rotation speed) is the speed at which the pilot begins to rotate the aircraft nose-up to lift off. It is a planned action point during the take-off run.
2. You are preparing a take-off performance calculation. The aircraft mass is higher than planned. How will this affect the rotate speed VR and the take-off safety speed V2?
- It will increase VR but decrease V2
- It will decrease both speeds
- It will increase both speeds
- It will decrease VR but increase V2
Show answer
Correct answer: It will increase both speeds
Higher aircraft mass requires higher airspeed to generate enough lift for rotation and to maintain the required climb gradient. Both VR and V2 increase with mass.
3. Which of the following correctly shows the relationship between take-off speeds V1, VR, and V2?
- V1≤VR
- V2 < VR
- V2≤V1
- VR ≤ V1 ≤ V2
Show answer
Correct answer: V1≤VR
V1 (decision speed) must not exceed VR (rotation speed), and V2 (take-off safety speed) must be at least equal to VR. The correct order is V1 ≤ VR ≤ V2.
Frequently asked questions about VR
What is the relationship between VR and V2 on large aeroplanes?
On large aeroplanes, rotation is made so that V2 (the take-off safety speed) is reached at a height of 35 ft. VR cannot be lower than V1.
What happens if rotation is made too early or too late?
Rotating too early causes the aeroplane to drag its tail due to an excessive angle of attack, leading to tail strike. Rotating too late lengthens the take-off distance.
Where is the VR value found for a light aeroplane?
On light aeroplanes, VR is given in the POH for a specific flap setting and weight. This speed may also be called liftoff speed.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 18 Nov 2026 · Report an error: [email protected]