Flap Setting
Turkish: Flap Ayarı
Flap setting is the angle of the movable surfaces on the trailing edge of the wing, selected for take-off and landing, which directly affects the aeroplane's performance, take-off distance and landing distance.
What is Flap Setting?
Flap setting describes the effect on the aeroplane's aerodynamic characteristics and performance of the flap position selected by the pilot, usually expressed in degrees such as 0°, 5°, 10°, 15°, 25° or 30°. When the flaps are extended, the wing area and camber increase, which increases lift but also increases drag significantly.
During take-off, using a partial flap setting (for example 5° or 10°) allows the aeroplane to become airborne over a shorter distance and improves climb performance. During landing, using full flap (for example 30° or 40°) allows a steeper approach angle, shortens the landing distance and helps keep the approach speed under control.
The flap setting must be selected within the limits defined by the AFM (Aircraft Flight Manual) or POH (Pilot's Operating Handbook). An incorrect flap setting can lead to increased take-off distance, reduced climb performance or loss of control during landing. Performance calculations (take-off distance, landing distance, climb speed) must always be made for the recommended flap setting.
Example
Example 2 - Landing: When landing on a short runway, the pilot approaches with 30° full flap; this gives a steeper approach angle and a shorter landing distance.
Example 3 - Performance calculation: The AFM contains tables such as "Take-off Distance (0° Flap, SL, ISA): 800 m" and "Take-off Distance (10° Flap, SL, ISA): 650 m".
Often confused with
| Flap Setting | Take-off Effect | Landing Effect |
|---|---|---|
| 0° (Clean) | Long take-off distance, good climb | Long landing distance, shallow approach |
| 5-10° (Take-off) | Short take-off distance, good climb | Medium landing distance |
| 25-30° (Landing) | Very long take-off distance, poor climb | Short landing distance, steep approach |
You are going to take off from a hot and high aerodrome (high density altitude). Which statement about flap setting is correct?
At high density altitude the take-off distance is already long. Full flap (30°) increases drag so much that climb performance drops to a dangerous level. The take-off flap setting specified in the AFM (typically 5-10°) provides the best balance.
Frequently asked questions about Flap Setting
How is the flap setting selected?
The flap setting must be selected within the limits defined by the AFM or POH. Performance calculations must always be made for the recommended flap setting.
How does extending flaps change the aeroplane's aerodynamics?
When flaps are extended, the wing area and camber increase. This increases lift, but also increases drag significantly.
What results from an incorrect flap setting?
An incorrect flap setting can lead to increased take-off distance, reduced climb performance or loss of control during landing.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 20 Nov 2026 · Report an error: [email protected]