MVA
Minimum Vectoring Altitude
MVA (Minimum Vectoring Altitude) is the lowest safe altitude that ATC may apply when radar vectoring aircraft within a sector. It provides minimum obstacle clearance above the obstacles in the radar sector.
What is MVA?
MVA stands for Minimum Vectoring Altitude and is called Minimum Vektörleme İrtifası in Turkish. When an air traffic controller (ATC) vectors an aircraft under radar control, that is, issues a new heading and altitude, the aircraft must not be descended below this altitude. Each MVA is defined within a specific radar sector and is calculated by adding a minimum obstacle clearance to the highest obstacle in that sector. In ICAO practice this clearance is generally taken as 300 m (1000 ft); in mountainous areas a higher clearance (600 m / 2000 ft) is applied. Exact values and sector boundaries may vary by country, so current values for Türkiye are published in the AIP (Turkish AIP).
MVA must not be confused with the Minimum En Route Altitude (MEA). The MEA is the altitude a pilot uses for flight planning along a published airway segment on their own. The MVA, by contrast, is the lower limit that a controller may use when vectoring an aircraft within radar coverage. In other words, the MVA limits the instructions a controller may give outside the aircraft's route. Similarly, the Minimum Sector Altitude (MSA) is an altitude defined around a navigation aid's centre for use in emergencies and serves a different purpose.
For the pilot, the importance of the MVA is as follows: when ATC issues a vector, the altitude guidance must be above the MVA, and the pilot should know that a safe lower limit exists while complying with the altitude instruction from ATC. The pilot should clarify over the radio with the controller to make sure the assigned altitude does not fall below the MVA. It should also be remembered that MVA protection ends when the aircraft leaves radar coverage or when radar service is terminated.
Often confused with
| MVA | MEA | MSA |
|---|---|---|
| Sector lower limit for radar vectoring | Lowest altitude for a published airway segment | Emergency altitude centred on a navigation aid |
| Used by ATC | Used by the pilot for planning | Used as a reference in emergencies |
| Depends on radar coverage | Depends on segment and radio coverage | Defined within a given radius |
Which is the lowest safe altitude that ATC may apply when radar vectoring?
MVA (Minimum Vectoring Altitude) is the lowest safe altitude that ATC may use during radar vectoring. MEA is used for airway segments and MSA for emergency sector altitude.
Frequently asked questions about MVA
What is the difference between MVA and MEA?
MVA (Minimum Vectoring Altitude) is the lowest altitude ATC may use when radar vectoring. MEA is the lowest en-route altitude used for flight planning on a published airway segment.
How does MVA work?
The MVA is set by adding a minimum obstacle clearance above the obstacles within a radar sector, and ATC does not vector below this altitude. Because exact values may vary by country, the AIP should be consulted for Türkiye.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 3 Nov 2026 · Report an error: [email protected]