MDA
Minimum Descent Altitude
MDA (MDH) is the altitude in a non-precision approach or circling approach below which descent must not be made without the required visual reference (referenced to QNH; height is MDH).
What is MDA?
Difference from DA: at the DA, a go-around is initiated at the moment of decision, and a short descent is accepted during the go-around. The MDA, by contrast, is an altitude that must not be descended below; the aircraft may level off at the MDA and continue to the MAPt.
Today most operators use the CDFA (continuous descent final approach) technique: the MDA is treated as if it were a DA, and sometimes a small margin is added on top of it (e.g. +50 ft) before the go-around is initiated.
Often confused with
| Minimum | Approach | Behaviour |
|---|---|---|
| MDA/MDH | Non-precision, circling | Do not descend below it; may level off and fly on to the MAPt |
| DA/DH | Precision, APV | Decision point; go around if no reference |
What can a pilot do at the MDA if no visual reference is available and the MAPt has not been reached?
In the classic technique, one may remain at the MDA until the MAPt (except CDFA).
How it is asked in the ATPL exam: 2 questions
Think about your answer, then reveal it.
1. You are planning a non-precision straight-in approach. Which pieces of information must you consider? (1) RVR or visibility (2) ceiling (3) minimum descent altitude or height (MDA/H) (4) decision altitude or height (DA/H). Which combination lists all the correct information?
- 1 - 4
- 1 - 2 - 3
- 1 - 2 - 4
- 1 - 3
Show answer
Correct answer: 1 - 3
Non-precision approaches require RVR/visibility and MDA/H. DA/H is used only for precision approaches; ceiling is not a regulatory requirement for non-precision minima.
2. Which items must be considered for a standard straight-in approach? (1) RVR/Visibility (2) ceiling (3) minimum descent altitude/height (4) decision altitude/height
- 1 - 3
- 1 - 2 - 4
- 1 - 4
- 1 - 2 - 3
Show answer
Correct answer: 1 - 3
For a straight-in non-precision approach, RVR/visibility and MDA/H are the critical factors. Decision altitude/height applies to precision approaches, and ceiling is not a regulatory minima term.
Frequently asked questions about MDA
What is the difference between MDA and DA?
The MDA (Minimum Descent Altitude) is an altitude that must not be descended below, and the aircraft may level off at the MDA and continue to the MAPt. At the DA, a go-around is initiated at the moment of decision, and a short descent is accepted during the go-around.
What is CDFA?
CDFA (continuous descent final approach) is a technique now used by most operators. In this technique the MDA is treated as if it were a DA, and sometimes a small margin (e.g. +50 ft) is added on top of it before the go-around is initiated.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 16 Nov 2026 · Report an error: [email protected]