Elevator
Turkish: Yükseltici
The elevator is a hinged control surface on the trailing edge of the horizontal stabiliser that controls the aircraft's pitch.
What is Elevator?
The elevator is the tail control surface that controls the aircraft's rotation about the lateral axis, that is, the up and down movement of the nose (pitch). It is hinged to the trailing edge of the horizontal stabiliser and is moved by the pilot's control input.
When the control column is pulled back, the trailing edge of the elevator rises and the airflow pushes the tail down, so the nose rises. When the column is pushed forward, the trailing edge drops and the nose lowers.
The elevator is separate from the rudder, located on the vertical tail section, and from the ailerons on the wings. The rudder controls yaw and the ailerons control lateral balance (roll); the elevator controls only the pitch axis. It is used in all longitudinal manoeuvres, including raising the nose on take-off, climb, cruise, descent and the flare on landing. On some aircraft the entire horizontal stabiliser is designed to move as a stabilator; in that case there is no separate elevator surface.
For the pilot, its importance is as follows: the effectiveness of the elevator changes with speed and load factor. Control effectiveness decreases at low speed, while excessive movement at high speed can create structural loads. In addition, the aircraft's longitudinal balance depends on the position of the centre of gravity (CG); as the centre of gravity moves aft, it becomes more difficult to balance with the elevator. For this reason, the elevator is a fundamental component where flight control and weight and balance calculations are closely linked.
Often confused with
| Elevator | Aileron | Rudder |
|---|---|---|
| Pitch (longitudinal axis) | Roll (lateral axis) | Yaw (normal axis) |
| Trailing edge of the horizontal stabiliser | Trailing edge at the outboard part of the wings | Trailing edge of the vertical stabiliser |
| Control column fore and aft | Control column left and right or wheel | Pedals |
Which tail control surface controls the aircraft's nose (pitch) movement?
The elevator is located behind the horizontal stabiliser and controls the pitch axis. The aileron provides roll control, the rudder provides yaw control, and the flap is used to increase lift.
How it is asked in the ATPL exam: 3 questions
Think about your answer, then reveal it.
1. Why is a double switch installed on the elevator trim control?
- to prevent both pilots from performing opposite trim inputs.
- to reduce the probability of a trim runaway.
- to be able to use two different trim speeds, slow trim rate at high speed and high trim rate at low speed.
- because there are two trim motors.
Show answer
Correct answer: to reduce the probability of a trim runaway.
A double switch (or dual-channel switch) reduces the risk of a trim runaway accident by requiring independent activation paths, so a single switch failure cannot cause uncontrolled trim movement.
2. During take-off, you observe that the aircraft rotates much faster than normal for the same elevator control input. What does this indicate?
- the centre of pressure is aft of the centre of gravity.
- the aeroplane is overloaded.
- the centre of gravity is too far forward.
- the centre of gravity may be towards the aft limit.
Show answer
Correct answer: the centre of gravity may be towards the aft limit.
Rapid rotation with normal input suggests the CG is near the aft limit, where less pitching moment is needed because the centre of gravity is closer to the centre of pressure. This makes the aircraft more pitch-sensitive.
3. During flight, the centre of gravity moves forward. What happens to the elevator control?
- become lighter making the aeroplane more easy to manouevre in pitch.
- become heavier making the aeroplane more easy to manouevre in pitch.
- become lighter making the aeroplane more difficult to manouevre in pitch.
- become heavier making the aeroplane more difficult to manouevre in pitch
Show answer
Correct answer: become heavier making the aeroplane more difficult to manouevre in pitch
A forward CG position increases the nose-down pitching moment, requiring greater elevator deflection to maintain pitch control. This makes the elevator feel heavier and the aircraft harder to manoeuvre in pitch.
Frequently asked questions about Elevator
What is the difference between an elevator and an aileron?
The elevator controls the up and down movement of the nose (pitch), while the aileron controls the lateral balance of the wings (roll). The elevator is located at the tail, whereas the ailerons are at the outboard part of the wings.
How does the elevator work?
The elevator is a surface hinged to the trailing edge of the horizontal stabiliser. When the control column is pulled back, the trailing edge rises and the nose rises; pushing the column forward has the opposite effect.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 8 Nov 2026 · Report an error: [email protected]