TAF Trainer: Read the Weather in Advance: the full explanation
Published: · Updated: · By: Son Yaklaşma editorial team
What is TAF?
TAF (Terminal Aerodrome Forecast) is the weather forecast issued for an aerodrome for the next 9 to 30 hours. While METAR gives the current observation, TAF tells you what the weather will be at departure, arrival and alternate aerodromes at the planned time of flight. That is why it is the key document for pre-flight planning. Its format resembles METAR, but it also describes changes with time groups.
| Group | Meaning |
|---|---|
TAF | Report type (AMD: amended, COR: corrected). |
LTFJ | ICAO code of the aerodrome. |
271100Z | Issue time: 11:00 UTC on the 27th of the month. |
2712/2818 | Validity: 12:00 UTC on the 27th to 18:00 UTC on the 28th (up to 30 hours). |
04015KT 9999 SCT025 | Main forecast: wind 040° 15 kt, visibility 10 km or more, scattered cloud at 2500 ft. |
FM271800 22010KT 6000 -RA BKN015 | Completely new forecast from 18:00; previous conditions are superseded. |
PROB40 2721/2803 2500 RA BKN008 | Between 21:00 and 03:00, 40% probability of visibility 2500 m and ceiling 800 ft. |
BECMG 2805/2807 32012KT 9999 FEW030 | Permanent change at some point between 05:00 and 07:00; definite after 07:00. |
Change groups: FM, BECMG, TEMPO, PROB
| Indicator | Meaning | In planning |
|---|---|---|
FM | Completely new forecast from the stated time | The previous main forecast and changes are no longer valid. |
BECMG | Permanent change beginning at any time within the period | Both old and new values are possible during the period; plan for the worse. |
TEMPO | Temporary fluctuations (each under 1 hour, total less than half the period) | The main forecast resumes when the period ends. If below minimums, an alternate is required. |
PROB30 / PROB40 | Condition occurring with 30% / 40% probability | If PROB40 is below minimums, treat it as TEMPO; note PROB30. |
PROB30 TEMPO | Probable temporary change | Often used for short-lived but hazardous events such as thunderstorms. |
How to find the weather at a specific time
- Is it within validity? If the time is outside the validity group, this TAF says nothing for that time.
- Start from the main forecast. The groups immediately following the validity are the starting conditions.
- Apply FM and completed BECMGs. FMs that have started by that time replace the main forecast entirely, while completed BECMGs change only the elements they give.
- Check the TEMPO/PROB covering that time. These do not change the main forecast; they show possible deterioration. Plan for the worst case.
Common mistakes
- Taking the issue time as the start of validity.
271100Zis the issue time; the forecast starts at2712/…. - Assuming a BECMG has occurred at the start of the period. The change may be delayed until the end of the period.
- Reading TEMPO as the main forecast. TEMPO is temporary; the main forecast resumes when the period ends.
- Carrying old elements over after an FM. FM is a completely new forecast.
- Treating SCT as a ceiling. The ceiling is only BKN, OVC or VV.
TAFs are obtained from aviationweather.gov and cached for up to 5 minutes. Small aerodromes may not issue TAFs. This is for training purposes only; the official meteorological briefing takes precedence in flight.
How is the TAF read?
- Find the validity. The GGSS/GGSS group that follows the issue time gives the start and end day/hour of the forecast.
- Read the main forecast. Wind, visibility, weather phenomena and cloud; same coding as METAR.
- Apply the FM groups. From the FM time onwards, the entirely new forecast is valid.
- Mark the BECMG periods. Within the period, both the old and new values are possible; after the period, the new value is definitive.
- Treat TEMPO and PROB as the worst-case scenario. If it covers your planned time and is below minimums, plan an alternate.
Frequently asked questions
What is a TAF, and how does it differ from a METAR?
METAR is the current observation of an aerodrome, issued roughly every 30–60 minutes. TAF is a 9–30 hour forecast for the same aerodrome and describes changes with the FM, BECMG, TEMPO and PROB groups.
What does FM mean in a TAF?
FM (from) indicates that a completely new forecast begins from the stated day, hour and minute. All previous values are invalid after FM.
What is the difference between BECMG and TEMPO?
BECMG is a change that begins at any point within the period and becomes permanent. TEMPO refers to temporary fluctuations; once the period ends, the main forecast applies again.
What do PROB30 and PROB40 mean?
Shows the conditions occurring with a 30% or 40% probability. Probabilities of 50% and above are not given with PROB but directly with TEMPO/BECMG.
How to read the TAF validity period?
For example, 2712/2818: from the 27th at 12:00 UTC to the 28th at 18:00 UTC. The first two digits are the day, and the next two are the hour.
Are the times in the TAF Turkish time?
No, all times are UTC. Add 3 hours for Turkish time.
Does every aerodrome issue a TAF?
No. TAFs are generally issued at aerodromes with scheduled traffic and a meteorological office; at small aerodromes there may be only a METAR.
Are my results being saved?
The coach is open to everyone. To see your quiz results and the question type you confuse most, simply sign up for free and log in.
Sources
- ICAO Annex 3, Meteorological Service for International Air Navigation: TAF
- WMO No. 306, Manual on Codes: FM 51 TAF
- Aviation Weather Center (NOAA): TAF data
- FAA, Aviation Weather Services (AC 00-45): TAF