Landing Distance Calculator

Change the weight, altitude, temperature, wind and runway surface (wet, snow, ice). Starting from the POH reference, watch the landing distance grow step by step, where the ground roll ends and how much runway is left.

PPLCPLPerformanceIntermediate
In short: What affects landing distance?

Landing distance is the distance from crossing 50 ft (15 m) above the threshold to a full stop; the ground roll is the part on the runway. It grows with weight, density altitude, tailwind and poor braking on wet, snowy or icy runways, so planning adds a safety factor of about ×1.43 to the POH figure.

Aircraft
POH reference: ground roll 661 ft · total from 50 ft 1,360 ft · 800 kg · touchdown speed 55 KT
720 kg
3 000 ft
25 °C
headwind 8 KT
3 000 ft
Runway surface
Safety factor
Preset scenarios
Ground Roll
—ft
Total from 50 ft
—ft
Runway required
—ft
Runway remaining
—ft
—

Runway view

Horizontal scale is true length; height is exaggerated

What lengthens the distance?

Step by step from the POH reference to these conditions
Density ratio
—
Touchdown ground speed
—
KT · Vtd ÷ √σ − wind
Hydroplaning speed
—
KT · 9 × √tyre pressure
Surface friction
—

How does it work?

The calculation starts from the POH reference (sea level, ISA, dry paved runway, no wind) and applies each factor in turn: weight (proportional), density (1 ÷ σ), wind (50% of headwind, 150% of tailwind; ground roll scales with the square of touchdown ground speed) and runway surface (braking friction).

The surface factors and the model are representative and meant for training. Use your aircraft’s POH charts for real planning.

In our glossary (Turkish)

Test yourself

A DA20 at 800 kg lands on a wet runway with a 5 KT tailwind: roughly how much longer is the total distance than the POH figure? Estimate first, then check it in the calculator.

Practice ATPL questions →

This simulator is for training only. Values are representative and do not replace the aircraft’s official POH/AFM, the AIP or current weather information in real flight operations. The pilot in command is always responsible.

Landing Distance Calculator: the full explanation

Published: · Updated: · By: Son Yaklaşma editorial team

Landing distance and ground roll

The POH gives two figures. The ground roll runs from touchdown to a full stop. The total landing distance also includes the air distance from crossing a 50 ft (15 m) obstacle to touchdown. Both are measured under ideal test conditions: a new aircraft, an experienced test pilot, a dry paved runway and maximum braking.

What lengthens the landing distance

Example: Diamond DA20 at 800 kg

Representative ground roll and total landing distance from 50 ft for a Diamond DA20 at 800 kg (simulator model, not POH data)
ConditionsGround rollTotal from 50 ftvs reference
POH reference (sea level, ISA, dry, no wind)661 ft1,360 ft×1.00
High and hot: 5,000 ft, 30 °C836 ft1,720 ft×1.26
Wet runway922 ft1,621 ft×1.19
5 KT tailwind854 ft1,648 ft×1.21
10 KT headwind546 ft1,182 ft×0.87
Compacted snow1,523 ft2,222 ft×1.63

Safety factor

A common rule is to multiply the POH figure by 1.43 for planning (UK CAA safety sense leaflets use ×1.43 for landing) or at least ×1.25–1.5 when no factor is already included. The simulator lets you choose ×1.0, ×1.25 or ×1.5 and shows how much runway is left.

Hydroplaning

Dynamic hydroplaning starts at about 9 × √tyre pressure (psi) knots. With 30 psi tyres that is about 49 KT, very close to a light aircraft’s touchdown speed. On standing water braking can almost disappear above that speed.

How to check the landing distance

  1. Find the POH figure. Enter the landing chart with pressure altitude, temperature and weight to get the ground roll and the total distance from 50 ft.
  2. Correct for wind. Use the chart corrections or count only 50% of a headwind and 150% of a tailwind.
  3. Correct for the surface. Apply the POH or regulatory factors for grass, wet, contaminated or sloping runways.
  4. Add a safety factor. Multiply by about 1.43 (or your operator’s factor) for planning.
  5. Compare with the runway. The factored distance must fit within the landing distance available (LDA) with margin to spare.

Frequently asked questions

What is the difference between ground roll and landing distance?

Ground roll is the distance from touchdown to a full stop. Landing distance (total) also includes the air distance from crossing a 50 ft obstacle to touchdown.

How much does a tailwind increase the landing distance?

Roughly 10% for every 2 KT of tailwind on a light aircraft, which is why many POHs and operators apply 150% of any tailwind. Even a small tailwind can use up the runway margin.

How much longer is the landing distance on a wet runway?

For a light aircraft the ground roll can be about 15–30% longer on a wet paved runway, and much more with standing water, snow or ice. Grass adds more again.

What safety factor should be applied?

A common planning factor for landing is ×1.43 (the UK CAA uses it in its safety sense leaflet), unless the POH figures are already factored. Commercial operations use regulatory factors.

At what speed does hydroplaning start?

Dynamic hydroplaning begins at about 9 × √tyre pressure (psi) knots: around 49 KT with 30 psi tyres.

Sources

More calculators