Reference Datum Point

Turkish: Referans Datum Noktası

PPLATPL Weight and Balance
IN SHORT

The Reference Datum Point is a fixed position defined relative to a specific point on the aircraft (usually the nose tip), taken as the zero reference for moment values in weight and balance calculations.

What is Reference Datum Point?

The Reference Datum Point (Datum) is an imaginary vertical plane that forms the basis of weight and balance analysis. The distance (arm) of each part of the aircraft (fuel tanks, passengers, cargo, etc.) from this point is measured and moment values are calculated. Moment = Weight × Arm.

The datum is usually located a specified distance forward of or aft of the nose tip (nose datum) and is stated by the aircraft manufacturer in the AFM (Aircraft Flight Manual). For example, it may be defined as "Datum, 100 inches forward of the nose tip". All moment calculations are made from this reference point.

Pilots and engineers use the datum to check whether the aircraft's centre of gravity (CG) is within the permitted limits. A CG forward of the forward limit or aft of the aft limit adversely affects the aircraft's controllability and performance. The datum must be known when carrying out the weight and balance calculation before take-off.

Example

If the AFM states "Datum: 100 inches forward of the nose tip" and the pilot's seat is 150 inches aft of the datum, then for an 80 kg pilot the moment = 80 × 150 = 12,000 inch-pounds. All loads are calculated in this way, and the CG percentage is found from the total moment and total weight.

Often confused with

DescriptionFixed?Calculated?
Reference Datum PointYes, defined by the manufacturerNo
Centre of Gravity (CG)No, varies with loadingYes, from moment calculations
TEST YOURSELF

On an aircraft, the datum point is defined 120 inches forward of the nose tip. A fuel tank is 80 inches aft of the datum and contains 150 kg of fuel. What is the moment of this fuel in inch-pounds?

Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 1 Nov 2026 · Report an error: [email protected]