OODA Loop

Observe-Orient-Decide-Act Loop

PPLATPLIR Human Performance
IN SHORT

The OODA Loop is the cycle in which a pilot observes a situation, evaluates it using personal experience and knowledge, decides on a course of action, and acts. It forms the basis of fast and accurate decision-making.

What is OODA Loop?

The OODA Loop (Observe-Orient-Decide-Act) is a model describing the four stages of the decision-making process in aviation. The pilot first observes the situation (Observe), then interprets this information with personal experience, training, culture and beliefs (Orient), then makes a decision (Decide), and finally carries out that decision (Act).

This loop is repeated continuously. For example, when a pilot notices an engine failure (Observe), evaluates it with training and procedures (Orient), decides on an emergency landing (Decide) and heads for a suitable aerodrome (Act). If the loop is completed quickly, the pilot stays ahead of the event; if it is completed slowly, the event gets ahead of the pilot.

ADM (Aeronautical Decision Making) aims to systematise this loop, helping the pilot reduce biases and cognitive errors. Stress, fatigue and distraction slow the loop down and increase the risk of error.

Example

Scenario: During the approach, the pilot notices that the runway visual range (RVR) is below the minimum value.

Observe: RVR 350 m, minimum 550 m.
Orient: The pilot considers their training, the characteristics of the aerodrome, the fuel state and alternate aerodromes.
Decide: The pilot decides to go around.
Act: Applies thrust, climbs, and informs ATC.

This loop must be completed within seconds.
TEST YOURSELF

A pilot notices an engine failure, but because they have never seen this failure in training, they misjudge the situation and continue the approach. At which stage of the OODA Loop was the error made?

Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 1 Nov 2026 · Report an error: [email protected]