DME
Distance Measuring Equipment
DME is a UHF system that measures the slant range, in NM, between the aircraft and a ground station. It is usually paired with a VOR or ILS.
What is DME?
The aircraft transmits a pair of interrogation pulses and the ground station replies after a fixed delay. The distance is calculated from the round-trip time.
The DME operates in UHF (962 to 1,213 MHz), but the pilot only selects the paired VOR or ILS frequency.
The measured value is slant range. When the aircraft is directly over the station at 6,000 ft, the DME indicates approximately 1 NM. This error is large near the station and at high altitude, and becomes negligible as distance increases (general rule: if you are at least 1 NM away for every 1,000 ft of altitude, the error can be ignored). DME can also display groundspeed and time to the station.
What does the DME indicate when directly over the station at 12,000 ft?
Slant range ≈ altitude: 12,000 ft ≈ 2 NM.
How it is asked in the ATPL exam: 3 questions
Think about your answer, then reveal it.
1. Under JAR-OPS, an operator must ensure the MDH for a VOR/DME approach does not go below what height?
- 200 ft
- 300 ft
- 250 ft
- 350 ft
Show answer
Correct answer: 250 ft
VOR/DME approaches are non-precision approaches; the minimum MDH is set at 250 ft to ensure adequate obstacle clearance.
2. At 0020 UTC, an aircraft crosses the 310° radial at 40 NM from a VOR/DME station. At 0035 UTC, the aircraft is on the 040° radial at 40 NM from the same station. Magnetic variation is zero. Determine the true track and ground speed.
- 090° - 232 kt
- 080° - 226 kt
- 088° - 232 kt
- 085° - 226 kt
Show answer
Correct answer: 085° - 226 kt
Plot both positions relative to the VOR/DME station, measure the track between the two points over 15 minutes, and calculate ground speed from distance and time.
3. An aircraft is flying inbound on a radial to a VOR/DME station. At 10:00, the DME distance is 120 NM. Three minutes later at 10:03, the DME reads 105 NM. What is the estimated time of arrival overhead the station?
- 10:27
- 10:24
- 10:21
- 10:18
Show answer
Correct answer: 10:24
The aircraft closes 15 NM in 3 minutes, giving a closing speed of 300 kt. At 105 NM distance remaining, time to station is 105 ÷ 300 × 60 = 21 minutes. ETA = 10:03 + 21 min = 10:24.
Frequently asked questions about DME
How does DME work?
DME works by the aircraft sending a pair of interrogation pulses, to which the ground station replies after a fixed delay. The distance is calculated from the round-trip time.
Why does DME show an incorrect distance when directly over the station?
DME measures slant range. When the aircraft is directly over the station, the value shown in NM is greater than zero because of altitude; this error is large near the station and at high altitude.
Machine-translated (AI) from our Turkish glossary entry using ICAO/EASA terminology. Updated 1 Nov 2026 · Report an error: [email protected]