ATPL Performance Questions (032)

Exam format, with explanations 10 question. No membership needed — choose an option, see the answer and explanation straight away.

ATPL Performance (032): 10 free exam-style practice questions with explanations, from a bank of 368 questions. Pass mark 75%.

0 / 10 answered✓ 0
Question 1 / 10General

What is the abbreviation for the stalling speed, or minimum steady flight speed at which the aircraft remains controllable, when the landing gear and flaps are fully extended?

Correct answer: C) VSO.

Explanation: VSO is the stall speed in the landing configuration (gear down, flaps down). VMC is minimum control speed, VS is stall speed in clean configuration, and VS1 is stall speed in a specific configuration but not landing configuration.

📖 In the glossary: VS

🔗 This question's page

Question 2 / 10Performance Class A: Aeroplanes Certificated Under CS25 Only

Which statement about drift-down procedures is correct?

Correct answer: D) When determining the obstacle clearance during drift-down, fuel dumping may be taken into account.

Explanation: Fuel dumping is an approved method to reduce aircraft weight during drift-down, which improves the descent gradient and helps clear obstacles. This is permitted and improves safety margins.

📖 In the glossary: Obstacle Clearance

🔗 This question's page

Question 3 / 10Climb

Take-off performance data with flap 10° shows: runway limit 5 270 kg, obstacle limit 4 630 kg. The estimated take-off mass is 5 000 kg. How will these limits change if flap 5° is selected instead?

Correct answer: D) 5°, the obstacle limit is increased but the runway limit decreases

Explanation: Reducing flap setting decreases drag and improves climb performance, so the climb-limited obstacle clearance mass increases; however, reduced flap increases take-off distance required, so the runway-limited mass decreases.

📖 In the glossary: RWY

🔗 This question's page

Question 4 / 10Take-off

An aircraft is loaded with 15400 kg of fuel, but the load sheet incorrectly shows 14500 kg. The crew does not catch this error. What will they observe during take-off?

Correct answer: C) speed at un-stick will be higher than expected

Explanation: Actual fuel is heavier than recorded, so the aircraft is heavier than calculated; this increases the speed needed to generate enough lift, so the un-stick (lift-off) speed will be higher than the crew's expected value.

🔗 This question's page

Question 5 / 10Cruise

A piston engine aeroplane achieves maximum endurance at which airspeed?

Correct answer: C) The speed that corresponds to the speed for maximum climb angle.

Explanation: Maximum endurance occurs at the speed for maximum climb angle, which minimizes fuel consumption per unit time and allows the aircraft to stay airborne longest.

📖 In the glossary: Endurance

🔗 This question's page

Question 6 / 10General

For turbojet-powered aircraft landing on a wet runway, the required landing field length at the destination aerodrome is calculated as the demonstrated landing distance plus _____.

Correct answer: C) 92%

Explanation: A 67% safety margin (equivalent to multiplying by 1.67 or using 0.6 of LDA) is required for wet conditions to account for reduced braking friction and other adverse factors.

📖 In the glossary: Landing Distance

🔗 This question's page

Question 7 / 10Performance Class A: Aeroplanes Certificated Under CS25 Only

According to JAR-OPS 1, for turboprop aeroplanes, the required runway length at a destination airport compared to an alternate airport is:

Correct answer: D) the same as that required at an alternate airport.

Explanation: Destination and alternate runway requirements are the same for turboprop aeroplanes under JAR-OPS 1. Both must meet identical performance standards for safety.

🔗 This question's page

Question 8 / 10Climb

Which formula correctly expresses the unaccelerated percentage climb gradient for small climb angles?

Correct answer: B) Climb Gradient = ((Thrust - Drag)/Weight) x 100

Explanation: Climb gradient depends on the net vertical force available: excess thrust above drag divided by weight, expressed as a percentage.

📖 In the glossary: Climb Gradient

🔗 This question's page

Question 9 / 10Take-off

For a jet aeroplane, V2 is defined as the _____ speed, measured at the point when the aircraft reaches 35 feet above the runway.

Correct answer: C) take-off climb speed or speed at 35 ft.

Explanation: V2 is the take-off climb speed—the minimum speed the aircraft must maintain during the initial climb after engine failure; it is measured at 35 ft height to standardize the definition.

🔗 This question's page

Question 10 / 10Cruise

A turbojet aeroplane's mass increases by 5% at a constant altitude. If engine specific fuel consumption remains unchanged, the hourly fuel consumption increases by approximately _____.

Correct answer: A) 5%

Explanation: For a turbojet, hourly fuel consumption is directly proportional to aircraft mass; a 5% mass increase causes a 5% increase in hourly consumption.

📖 In the glossary: ALT

🔗 This question's page

🔒 11. question onwards open to membersSign up free

ATPL Performance what comes up in the exam?

The Performance lesson covers take-off, climb, cruise and landing performance; Class B single and multi-engine (SEP/MEP) charts, Class A (CS-25) take-off calculations, V1/VR/V2, single-engine failure cruise and MRJT charts. The questions above were selected from different sections of these topics.

See also: Landing distance calculator · Density altitude · ATPL exam guide · All ATPL lessons

ATPL Performance — questions with explanations

Frequently asked questions

How many subjects does the ATPL theory exam consist of?

EASA Part-FCL ATPL(A) theory consists of Air Law (010), Airplane General Knowledge (021), Flight Instruments (022), Mass and Balance (031), Performance (032), Flight Planning (033), Human Performance (040), Meteorology (050), General Navigation (061), Radio Navigation (062), Operational Procedures (070), Principles of Flight (081) and Communications. In the old syllabus, Communications is split into VFR (091) and IFR (092); in the post-2020 syllabus it appears as a single subject (090).

Within what period must the ATPL exams be completed?

According to Part-FCL (FCL.025) rules, all subjects must be completed within 18 months from the end of the calendar month of the first exam sitting. There is a maximum of 6 sittings and a maximum of 4 attempts per subject. Follow SHGM announcements for current practice.

Are the ATPL questions in English?

Yes. ATPL theoretical knowledge and exam terminology are in English, so the questions in this bank are also prepared in English. Under each question there is an English explanation and, in most cases, a short Turkish note.

What is the pass mark?

You need at least %75 in each ATPL subject. At the end of the sample test, you compare your score with this threshold.

Are these past exam questions?

No. SHGM and EASA do not publish exam questions. The questions here are study questions in exam format, prepared according to the learning objectives of the EASA ATPL syllabus.

What is the difference between PPL and ATPL questions?

PPL covers the core topics of the private pilot licence. ATPL deepens the same topics to airline level (turbine engines, pressurisation, Class A performance, high-speed aerodynamics, PANS-OPS, IFR planning with Jeppesen) and adds separate subjects such as Flight Instruments, Mass and Balance and Radio Navigation.

Is the sample test free?

Yes. A sample test of 10 questions for each ATPL subject can be solved without membership. Free membership is enough for the full bank, topic-by-topic study, my mistakes list and timed mock exams.